The inhibiting action of intrinsic impurities in natural calcium carbonate minerals to their dissolution kinetics in aqueous H2O-CO2 solutions. Geochim.
- Permanent Link:
- The inhibiting action of intrinsic impurities in natural calcium carbonate minerals to their dissolution kinetics in aqueous H2O-CO2 solutions. Geochim.
- Series Title:
- Geochimica et Cosmochimica Acta
- Eisenlohr, Laurent
- Publication Date:
- serial ( sobekcm )
- We have measured the surface controlled dissolution rates of natural calcium carbonate minerals (limestone and marble) in H2Oâ€“CO2 solutions by using free drift batch experiments under closed system conditions with respect to CO2, at 10°C with an initial partial pressure of carbon dioxide of 5 · 10âˆ’2 atm. All experiments revealed reaction rates F, which can be described by the empirical relation: Fn1 = kn1 · (1 âˆ’ c/ceq)n1 for c < cs, which switches to a higher order n2 for calcium concentrations c â‰¥ cs described by Fn2 = kn2 · (1 âˆ’ c/ceq)n2. kn1 and kn2 are rate constants in mmole/(cm2 · s), ceq is the equilibrium concentration with respect to calcite. The values of the constants n1, n2, kn1, kn2 and cs depend on the V/A ratio employed, where V is the volume of the solution and A is the surface area of the reacting mineral. Different calcium carbonate minerals exhibit different values of the kinetic constants. But generally with increasing V/A, there is a steep variation in the values of all kinetic constants, such that the rates are reduced with increasing V/A ratio. Finally with sufficiently large V/A these values become constant. These results are explained by assuming intrinsic inhibitors in the bulk of the mineral. During dissolution these are released from the calcite matrix and are adsorbed irreversibly at the reacting surface, where they act as inhibitors. The thickness d of the mineral layer removed by dissolution is proportional to the V/A ratio. The amount of inhibitors released per surface area is given by d · cint, where cint is their concentration in the bulk of the mineral. At low thicknesses up to â‰ˆ3 · 10âˆ’4 cm in the investigated materials, the surface concentration of inhibitors increases until saturation is attained for thicknesses above this value.
To analyze the surface concentration and the type of the inhibitors we have used Auger spectroscopy, which revealed the presence of aluminosilicate complexes at the surface of limestone, when a thickness of d â‰ˆ 10âˆ’3 cm had been removed by dissolution
- Original Version:
- Geochimica et Cosmochimica Acta, Vol. 63, no. 7-8 (1999-04).
- Source Institution:
- University of South Florida Library
- Holding Location:
- University of South Florida
- Rights Management:
- This object is protected by copyright, and is made available here for research and educational purposes. Permission to reuse, publish, or reproduce the object beyond the bounds of Fair Use or other exemptions to copyright law must be obtained from the copyright holder.
No images or PDF downloads are available for this resource.
Cras ut cursus ante, a fringilla nunc. Mauris lorem nunc, cursus sit amet enim ac, vehicula vestibulum mi. Mauris viverra nisl vel enim faucibus porta. Praesent sit amet ornare diam, non finibus nulla.
Cras efficitur magna et sapien varius, luctus ullamcorper dolor convallis. Orci varius natoque penatibus et magnis dis parturient montes, nascetur ridiculus mus. Fusce sit amet justo ut erat laoreet congue sed a ante.
Phasellus ornare in augue eu imperdiet. Donec malesuada sapien ante, at vehicula orci tempor molestie. Proin vitae urna elit. Pellentesque vitae nisi et diam euismod malesuada aliquet non erat.
Nunc fringilla dolor ut dictum placerat. Proin ac neque rutrum, consectetur ligula id, laoreet ligula. Nulla lorem massa, consectetur vitae consequat in, lobortis at dolor. Nunc sed leo odio.